Updates have been less frequent, frankly, because progress is harder to visually measure. I've been sanding the hull and patching cracks. The patching takes some time because one must let the epoxy/sawdust mixture cure completely before sanding again. However, I finally cut the cord on that. I put on the "sealer coat" of epoxy resin. Here's a view from the front.

The idea of the sealer coat is to get a layer of epoxy on the wood before fiberglass. Then, 24 or so hours later, pop on the fiberglass. This is a view of the back of the hull.

This is a closer view of the same angle as above.

View from the back to the front.

A view of the flat bottom section of the hull.